PDCWB Motobatt Waterboy 12V Charger

(0) No Reviews yet
RRP: $60.35

Out of Stock


PDC WaterBoy 12 Volt 1.0 Amp Charger Maintainer Intelligent 9 Step Automatic Charger Fully Waterproof. Outdoors in all weather. Sleek New Design with easy to read Charge Indicator Latest in Electronic Microprocessor and optimized for all Motobatt and Standard Batteries. Application: Fully Submersible Waterproof Charger will keep you operational in wet conditions. Snowmobile, ATV, Watercraft, Generator, Farm Vehicles Motobatt's clever Microprocessor reads the correct voltage of the battery connected, the 9 Phase process monitors the battery resistance 100's of times per second during charging mode. Qualification Stage checks the battery is over 2V for safety reasons, then transitions to "Rescue" Phase where an arsenal of 5 different recovery modes can be utilised to revive heavily Sulphated or deeply discharged batteries. Generally at this stage unusually high voltage is seen early in the charge cycle, once the rescue phase is done the battery is ready for Soft Start Phase When the charger detects a low initial state of charge, voltage and current are delivered at a specific rate to assist the battery recovery before entering Pulse charging mode. Pulse Phase provides a high frequency pulse charge to help the newly recovering battery to accept charge as it enters recondition mode. Recondition Phase continues to work the battery at a slightly higher voltage and amperage to re-activate the battery plates for improved depth of charge. Now that the battery has been eased back to life……. Bulk charge phase can begin giving constant current to the battery up to about 80% of its capacity. Absorption Phase begins with constant voltage being supplied while current is reduced. This occurs according to the batteries ability to accept charge up to 100%. Check Phase is now activated to monitor the batteries ability to hold the charge properly, if not it will cycle back through the entire process for 24 hours or more until it determines the battery cannot be recovered. For revived batteries it then enters Maintenance Phase where the battery can stay indefinitely connected to the charger. As the battery drops voltage while unused, the unit will activate when needed to ensure a full state of readiness. Keeping your batteries properly maintained will dramatically Extend working Life.


PDCWBPart Number PDCWB Motobatt Water Boy 12V Lead Acid Charger
Voltage12 Volt
Capacity1 Amp
Algorithm9 Step Automatic Charging and Maintaining
InputAuto Switching 120-240VAC-50/60Hz
Max Voltage14.8 Volt
Input Cable6Ft 18AWG, US SPT-2, EU-H03VV
Application12V Batteries Standard flooded, AGM, GEL, Lithium
Special FeaturesWaterproof, Snowproof, Overcharge Protection, Reverse Polarity protection, Short circuit protection, Spark Proof, Battery Recovery Mode
Accessories IncludedMB-CCRT 21" Length, 6mm Diameter Ring Terminal with 7.5A Fuse and 2DIN connector plug, MB-CCAC 21" Length, Alligator Clip Leads
Wall MountableYES
Recommended BatteryCharging 2-32AH Maintenance-100AH Lead Acid, AGM, GEL Battery

WARNING: This product can expose you to chemicals including Sodium salt, Lead and Lead, Nickel (Metallic), which are known to the State of California to cause cancer or birth defects or other reproductive harm.
For more information, visit https://www.p65warnings.ca.gov/.


Ask a Question

Product Enquiry

Welcome to the contact us form. Please select the reason for your contact today from the drop-down menu, and let us know how to get hold of you by filling in the form and what times we can reach you. Enquires can take 24-48 hours depending on demand, but we will do our best to get right back to you!

Ratings & Reviews

No reviews available

Be the first to Write a Review